SR25-3828VD0171B 1-3 CL - OVERVIEWOVERVIEW (continued)CONNECTION CENTER ON BACK OF TVThe connection center on the rear of the TV allows forconnection of the viewing source. The diagrams list theuse of each jack on the connection center.1. ANTENNA/CABLE JACKUse the jack for 75-ohm antenna-type signalconnections to the TV. Attach antenna, cable TV line,or other video equipment to jack. The input cable maycome from an outdoor or master antenna, cable TV line,cable decoder box, or the RF output from a VCR.2. SUPERPORT LOCATIONProvides for easy installation of local service provideraccessory module without removing the cabinet back.Module is housed inside the TV cabinet and receivesoperating power and all necessary interface signalsthrough internal connections.3. MPI (MULTIPLE PROTOCOL INTERFACE) JACKStandard RJ11 jack that provides interface with in-room entertainment and video services. Also used withinstaller’s programmer (page 1-5) for programming otherTVs in the system with the same features as the masterTV.4. S-VIDEO IN AND OUTThese jacks are for input and output connections toSUPER-VHS video equipment. Use the input jack forviewing S-Video. Use the output jack to loop the S-Video signal to an additional TV or monitor. The rightand left audio jacks are used for stereo input or outputpaired with the S-Video Signal.5. VIDEO IN AND AUDIO INUse the Video and Audio In jacks for baseband videoand audio input signals from a VCR or other signal source.6. MATRIX SPEAKER OUTUse this jack for connection of an 8-ohm extensionspeaker to get television sound at a remote location.The speaker in the TV remains active, while a monauralaudio output is heard from the remote speaker.7. EBC KNOBFor handling/removal of EBC (Edge Board Card).SuperPort M. P. I.ANTENNACABLE142 37 7 6VIDEO IN AUDIO INMATRIX OUTRR AUDIO INLLS-VIDEO IN5SuperPort M. P. I.ANTENNACABLE12 37 7 6VIDEO INMATRIX OUTAUDIO IN5Used on HXXXX34DTUsed on HXXXX36DT modelsANT ENNACABLE17 7 6VIDEO INMATRIX OUTAUDIO IN5Used on HXXXX39DT