Zenith SY3238 Operating Manual & Warranty

Contents

I IllSTANDARD CONNECTIONS FOR YOUR TVI lSETUP 3: TV ANDVCRIf you receive your television signal through your VCR, connect_ourtelevision as follows:Cable Leading from.. Connects to..A 75-ohm cable from "VHF In" (From Antenna)Antenna or cable-TV jack of VCR.wall jack.B & C Not required.D ANTENNA/CABLEconnector on TV.E Corresponding "Video,""Audio R" and "Audio L"input jacks on the back ofthe TV.NOTE:O75-ohm cable fromVCR's "VHF Out" (ToTV) jack.Audio/Video (A/V)cables from "VideoOut," "Audio R Out"and "Audio L Out" jackson the back of VCR.If your antenna has a flat (300-ohm) wire leading from it, youwill have to attach this wire to a 300-75 ohm adapter before theantenna can be connected to the VCR.Flat wirefrom antenna(300 ohm)o,°, 300/75 ohm :Adaptor ,_"-.":::::vcn BACKSetup 3 describes the basic connection of your TV if you wishto properly use the PIP feature. With your equipment setup inthis manner, your television has the following PIP capabilities:Q Watch a vide() tape (playing in the VCR) in the TV's mainpicture area and simultaneously watch a TV channel in thePIP window.Q Watch one channel (selected by the TV's tuner) in theTV's main picture area and simultaneously watch anotherchannel (selected by the VCR's tuner) in the PIP window.For further details on PIP, refer to the "PIP Operation" sectionof this operating guide.SETUP4: TV WITH VCR AND CABLE BOXIf you receive your television signal through your VCR and cablebox, connect your television as follows:Cable Leading from.. Connects to..A Not required.B 75-ohm cable from cable- Input connector of cableTV wall jack. box.C 75-ohm cable from "VHF In" (From Antenna)output connector of Ijack of VCR.cable box.D ANTENNA/CABLEconnector on TV.E75-ohm cable fromVCR's "VHF Out" (ToTV) jack.Audio/Video (A/V)cables from "VideoOut," "Audio R Out"and "Audio L Out" jackson the back of VCR.Corresponding "Video,""Audio R" and "Audio L"inputjacks on the back ofthe TV.SETUP 3 and SETUP 4OXBACKBACI