Zenith Z44SZ80 Installation And Operating Manual

Also see for Z52SZ80: Installation and operating guide Specifications Service manual Service manual Service manual

34 DLP Projection TVOperation- PIP lets you view 2 different inputs (sources) on your TV screen at the same time. One source will be large, and the othersource will show a smaller inset image.- Twin Picture mode splits the screen into 2, allowing 2 picture sources to be shown on the TV screen at the same time. Eachsource is given half the screen.- If you set the block/rating for Lock menu options in PIP/Twin Picture mode, “Rating Blocked” doesn’t display on screen.Press the PIP button to access the sub picture. Each press of PIP changes the PIP options as shown below.PIP OffPIP Mode Twin Picture Mode1. Press the PIP button.2. Select the Antenna or Cable option on the Sub input menu or with the PIP INPUT button. Use the PIPCH+ /PIPCH- button to select a channel for the sub picture.(You can’t select DTV for main and sub picture simultaneously).Repeatedly, use the SWAP button to switch the main and sub pictures.• Component 1, Component 2, RGB-PC (or RGB-DTV), HDMI/DVI input sources for the main picture can’t be used toswap the main and sub pictures.Use the PIP INPUT button to select the input source for the sub picture. Each press of PIP INPUT button changesthe PIP source. You can also select sources for the Sub Input in the SETUP menu.Main Picture Source Available Sub Picture SourcesDTV, Analog Video, and Front VideoSub Picture Main Picture Sub PictureMain PictureRemote ControlRemote ControlPIP (Picture-In-Picture) / Twin PictureWWatching PIP/Tatching PIP/Twin Picturewin PictureSelecting an Input Signal Source for PIP/TSelecting an Input Signal Source for PIP/Twin Picturewin PictureSwapping the PIPSwapping the PIP/T/Twin Picturewin PictureTV Program selection for PIPTV Program selection for PIP