Zip HydroTap BCS160 Installation Instructions Manual

Contents

Zip HydroTap BCS160 Installation Instructions Manual Manual pdf 35 page image

801910 - Zip Sparkling HydroTap - Installation Instructions - July 2014 - V1.00 Page 35 of 40The HydroTap is now ready to be commissioned.• Turn on the power, gas and water and check for any leaks• Familiarise yourself with the operation of the Tap, in preparation for use (See User Guide)• Follow the Installation instructions below (and review Section C of the User Guide).• After commissioning, the system may be customised by selecting further options in Section G -Settings, within the User Guide.1. Press [Start] [Stop] buttons to start and stop the filterflush.2. Turn the flush line stop cock ON (See diagram).3. Press [Start] and allow at least 10 litres of water to flushthrough the filter.4. The product details will be displayed in the screen.5. Once the filter flush is finished, Turn the stop cock OFFthen press [Stop] to end filter flush mode.6. Press [Next] for the Boiling Calibration screen.Have a bucket or similar container (not supplied) at the ready to hold a quantity of water that will be ejectedwhile the Filter Flush Mode is in operation. Open the filter access door on the front of the HydroTap and thefilter cartridge will be exposed. Located to the rear RHS of the cartridge is a flush line, approx 600mm longand the flush line stop cock. Place the free end of the flush line into the bucket or container (not supplied).7.2 - Filter FlushSection 7Commissioning7.1 - CO2 Purge1. Press the [START] button to commence the purgingprocess.2. Purge for 10 seconds and ensure all water has stoppedflowing through the tap. (You will hear the CO2 gasescaping from the tap).3. Press the [Stop] button.4. Press [Next] for the filter flush screenNOTE: at first commissioning, the system will select the CO2 Purge screen automatically.