Zip HydroTap BCS160 Installation Instructions Manual

Contents

Zip HydroTap BCS160 Installation Instructions Manual Manual pdf 5 page image

801910 - Zip Sparkling HydroTap - Installation Instructions - July 2014 - V1.00 Page 5 of 40Important Safety InstructionsWARNINGS1. The Zip HydroTap unit must be earthed. The resistance of the earth connection from each exposedmetal part must be less than 1 ohm.2. All Installation and service work must be completed by trained and suitably qualifiedTradespeople. Faulty operation due to unqualified persons working on this product, orany other Zip product may void warranty coverage.3. All Plumbing must comply with AS/NZS3500.4. All Electrical must comply with AS/NZS30005. All Plumbing and Electrical connections must be made in accordance with local regulations.6. This HydroTap product is rated for 230V 50Hz AC operation.7. Underbench units must never be located near, or cleaned with water jets.8. Zip HydroTaps are not to be exposed to the elements of nature9. Due to the process of continuous improvement, Zip Heaters reserves the right to change detailsmentioned in this manual, without notice.2.64 Kg CO2 Cylinder Warnings:• Pressurised container.• Protect from sunlight.• Contains gas under pressure, may explode if heated.• Do not expose to temperatures exceeding 50˚C.• Do not pierce or burn, even after use.• Do not expose to naked flame or any incandescent material.• Keep out of reach of children.• High concentration of gas may cause asphyxiation.• Use only in ventilated areas.• Store in an area no less than 100 cubic meters for each 2.64 Kg bottle.• Use only in an upright position.• This bottle must be used with the approved pressure regulator.• Avoid shock.• Use according to MSDS. (Material Safety Data Sheet).AltitudeWater boils at varying temperatures at different altitudes. Your HydroTap adjusts for this during startupcalibration and will recalibrate itself on a regular basis.Frost ProtectionIf this appliance is located where the ambient air temperature could fall below 5ºC when the heater is notin use, do not turn off the appliance electrically. This safeguard does not offer the same protection to theconnecting pipework and fittings.edPositioningIt is important to ensure the underbench unit is positioned in an accessible area close to the floor level. Theunit must have it’s base mounted in a horizontal position with all inlets and outlets facing up. The Tap must belocated above the underbench unit. See page 12 for details.