Zip Hydrotap G4 Series Installation Instructions Manual

Also see for HydroTap G4 Series: Installation instructions Installation instructions Installation instructions Installation instructions User manual

Contents

21INSTALLATION I N STRUCTIONS803341UK V1.04 NOV 2017 - ZIP G4 TAP RANGETECHNICAL SUPPORT TEL: 0345 6 005 005 EMAIL: SERVICE@ZIPINDUSTRIES .CO.UKWWW.ZIPWATER.CO.UKSECTION 7 CELSIUS TAP INSTALLATION220330251Ø23Ø49220402257Ø23Ø49ArcCubeCelsius7.1 Dimensions• Slide upper rubber washer in place on underside of tap.• Mount tap in position on Ø35mm hole.• Slide lower rubber washer, metal washer then tap nut over the threaded boss, then tighten the tap nut tosecure in place, do not over tighten.• Match the colour markings on the braided hoses to those of the copper extension tubes. Attach thebraided hoses (ensure the seals on the end of the hoses are lubricated), do not over tighten.• Attach the braided hoses to the mains hot and ambient supply (see sections 7.5, 7.6).• Attach the USB connector to the corresponding connector from the Command-Centre.7.2 Cut the hole & mount the tap (see sections 7.3, 7.4)Cut a Ø35mm hole in the worktop / sink.Note Make sure the tap location will allow the tap spout to drain into the sink.Ø35mmDimensions in mm