Zip Hydrotap G4 Series Installation Instructions Manual

Also see for HydroTap G4 Series: Installation instructions Installation instructions Installation instructions Installation instructions User manual

Contents

08INSTALLATION I N STRUCTIONS803341UK V1.04 NOV 2017 - ZIP G4 TAP RANGETECHNICAL SUPPORT TEL: 0345 6 005 005 EMAIL: SERVICE@ZIPINDUSTRIES .CO.UKWWW.ZIPWATER.CO.UKSECTION 2 ARC & CUBE HYDROTAP INSTALLATIONThe HydroTap Arc/Cube has a spout that may be fixed in 1 of 6 angular positions (depending on theposition of the rotary control) and fixed in one of two height positions. The spout is fixed and does not swivel.To reduce the risk of scalding, Position *A should not be selected with any of the boiling water models.(See section 2.3).2.1 Tap configuration• Remove the 2 x spout locating screws and lower the spout to expose the plastic spring clip.Note The plastic spring clip has two internal dimples that may be positioned in the 6 upper or 6 lower,pre drilled holes in the spout (see diagram below & sections 2.2 & 2.3).• To reposition the spout, gently spread the plastic spring clip to release the dimples from the spoutholes. When released, slide the clip on the spout so that it endsup between the two rows of holes.• Rotate the plastic clip on the spout to orient the dimples, so theyare in line with the newly selectedholes.Note When determining which of the 6 holes are required for thenew spout height and orientation, check the new plastic clip positionwill clear the undercut and that the USB lead will not be pinched,when assembled.• Slide the plastic clip up/down to engage with the selected holes,making sure the two dimples engage simultaneously with thetwo selected holes.Note The clip will not fit correctly if one dimple engagesbefore the other. Both dimples must engage at the same time.• With the clip fitted to the newly selected holes,carefully raisethe spout (ensure the USB lead is a neat fit in the undercutand is located between the open ends of the clip) until theclip locating holes are in line with the spout locating screws.• Replace the 2 x locating screws.• If mounting on an uneven surface, apply a light smearing ofsilicon sealant on the o-rings to ensure a watertight fit. (Seesection 2.4).• Pass the assembly (ensuring uppero-ring, base ring and lower o-ringare in place) through the Ø35mmhole and position the tap so itdischarges into the sink.• Fit the lower rubber seal to thethreaded extension.• Secure the tap in position with themetal washer and nut.Spout locatingscrews (2)Undercutfor USBLower locatingpositionsPlasticspring clipUpper locatingpositionsClip locatingholes (2)DimplesPlastic spring clip!Arc / Cube