04INSTALLATION I N STRUCTIONS803341UK V1.04 NOV 2017 - ZIP G4 TAP RANGETECHNICAL SUPPORT TEL: 0345 6 005 005 EMAIL: SERVICE@ZIPINDUSTRIES .CO.UKWWW.ZIPWATER.CO.UKGENERIC INSTALLATION INSTRUCTIONSTap installation special tool requirementsIn addition to normal tools, the following (or equivalent equipment) will be required.For the HydroTap G4, Celsius and mixer taps (for Celsius All-in-One Arc see below).• 35mm diameter sheet metal hole punch for sinks (not supplied).• 35mm diameter hole saw for worktops (not supplied).• Nut runner tube spanner (supplied for all but Celsius & mixer taps) for fixing the tap assembly.For the All-in-One tap & Celsius All-in-One Arc.• 50mm diameter sheet metal hole punch for sinks (not supplied).• 50mm diameter hole saw for worktops (not supplied).• Nut runner tube spanner (not supplied for Celsius All-in-One Arc) for fixing tap assembly.Font installation special tool requirements• Hole saw or equivalent equipment to suit surface being cut. Ø140m for Arc / Cube and Ø108mm for Classicand Elite.Arc / CubeElite Classic ClassicventedAll-in-Onemains ORventedCelsiusmainsMixer tapsHydroTapsMin / Max water supply pressure requirementsHydroTaps and Mains All-in-One & Celsius taps sparkling models..................0.25 MPa (2.5 bar) - 0.5 MPa (5 bar)HydroTaps and Mains All-in-One & Celsius taps non-sparkling models...........0.17 MPa (1.7 bar) - 0.5 MPa (5 bar)Vented All-in-One sparkling models..................................................................0.25 MPa (2.5 bar) - 0.5 MPa (5 bar)Mixer taps and Vented All-in-One non-sparkling model taps............................0.20 MPa (2.0 bar) - 0.5 MPa (5 bar)Using these instructionsThese instructions are provided primarily to demonstrate how to install HydroTap G4 taps and do not providesufficient information to install and commission complete HydroTap G4 systems. Please refer to all safety andinstallation requirements detailed in the installation instructions provided with the Command-Centre prior to anychange to the complete system.ArcmainsCubemainsCelsiusAll-in-One ArcmainsNOTE It is recommended to use a water block device to minimise the potential for water leakage in the event of a systemmalfunction, please refer to the Command-Centre installation instructions for details.