Chapter 2 - SmartController Installation28 Adept SmartController User’s Guide, Rev. EStacking ComponentsTo stack mount the SmartController and an sDIO or sMI6 module, install two brackets oneach side of the units, as shown in Figure 2-4. These brackets are supplied with the sDIOand sMI6 modules.Figure 2-4. Stack Mounting the SmartController and sDIOCompactFlash Memory CardThe SmartController is equipped with a CompactFlash ™ (CF). The SmartControllersystem uses a CF in place of a traditional hard disk drive. In fact, it is often referred to as a“solid state hard drive”. The CF is about half the size of a credit card and twice as thick. Ithas no moving parts and is therefore reliable and durable. It is also removable and can bemoved to another SmartController for replacement or testing.The CF capacity shipped with all systems is currently 30 MB and is factory configured byAdept. The CF stores the V+ operating system, optional AIM software, applicationprograms, data files and Adept licenses.NOTE: Adept reserves the right to increase the size of the CF withoutnotice.76.530.7120.98X M3 x 6MMBOTH SIDES28.1 16.02X 40356-00002BOTH SIDES186.5133.0328.9SW1SmartController CSXSYSOKLINKXDC1 XDC224V 0.5AHPE1.1 1.2 X21.1 1.2SC-DIODevice Net1 2 3IEEE-1394SFRS-422/485LANXMCP-+ -+RXDC1 XDC2X3SFRS-232/TERM-+ -+*S/N 3561-XXXXX*IEEE-1394ES24V 5AXFPOKX4ONHDEth 10/100OFF1 2 3 4XUSRRXDIOX1*S/N 3563-XXXXX*
