laerdal SimMom Directions For Use Manual

laerdal SimMom Directions For Use Manual Manual pdf 26 page image

26Performing SimulationsPelvic ComponentsModular ComponentsSimMom is equipped with the following modular components:1. Cervix Module 3. Postpartum Hemorrhage, includingBoggy Uterus and Retained Placenta2. Amniotic Bag 4. Inverted UterusCervix Installation1. Fold back or remove abdominal skin (see Maintenance sectionpage 37, “Abdominal Skin Replacement”).Caution: Folding the skin downward without supportunderneath it may cause the skin to tear.2. Unscrew the three black thumbscrews around pelvic ring clamp.Remove pelvic ring clamp from clamping face.Note: When removing pelvic ring clamp, lift so that it remainsparallel with the pelvis until it is clear of the screws.3. Remove current cervix module if necessary and set aside.4. Place new cervix module in position at pelvic inlet with flangelying on top of birth canal flange.5. Carefully align holes on cervix module with locating pins onclamping face. Ensure that urinary connector is aligned withsimilar notch on cervix module.6. Replace pelvic ring clamp. Ensure it is properly aligned withlocating pins and urinary connector.7. Position and tighten black thumbscrews until firm.Note: Do not over tighten thumbscrews.Reservoir CoverPelvic RingCervixPubic BonePelvic FloorPelvic Floor PlateSkin PlatePerinium and Birth CanalPopper BarThumbscrew