u-blox SARA-R4 Series System Integration Manual

Contents

SARA-R4 series - System Integration ManualUBX-16029218 - R06 ApprovalsPage 86 of 102Radiofrequency radiation exposure Information: this equipment complies with radiationexposure limits prescribed for an uncontrolled environment for fixed and mobile use conditions.This equipment should be installed and operated with a minimum distance of 20 cm betweenthe radiator and the body of the user or nearby persons. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter except as authorizedin the certification of the product.The gain of the system antenna(s) used for the SARA-R4 series modules (i.e. the combinedtransmission line, connector, cable losses and radiating element gain) must not exceed the valuestated in the IC Grant for mobile and fixed or mobile operating configurations:o SARA-R410M-01B modules:o 3.67 dBi in 700 MHz, i.e. LTE FDD-12 bando 4.10 dBi in 850 MHz, i.e. LTE FDD-5 bando 6.74 dBi in 1700 MHz, i.e. LTE FDD-4 bando 7.12 dBi in 1900 MHz, i.e. LTE FDD-2 band4.3.2 ModificationsThe ISED Canada requires the user to be notified that any changes or modifications made to this device that arenot expressly approved by u-blox could void the user's authority to operate the equipment.Manufacturers of mobile or fixed devices incorporating the SARA-R4 series modules areauthorized to use the ISED Canada Certificates of the SARA-R4 series modules for their ownfinal products according to the conditions referenced in the certificates.The ISED Canada Label shall in the above case be visible from the outside, or the host deviceshall bear a second label stating:o For SARA-R410M-01B modules: "Contains FCC ID: 8595A-2AGQN4NNN" resp.Innovation, Science and Economic Development Canada (ISED) NoticesThis Class B digital apparatus complies with Canadian CAN ICES-3(B) / NMB-3(B).Operation is subject to the following two conditions:o this device may not cause interferenceo this device must accept any interference, including interference that may cause undesiredoperation of the deviceRadio Frequency (RF) Exposure InformationThe radiated output power of the u-blox Cellular Module is below the Innovation, Science andEconomic Development Canada (ISED) radio frequency exposure limits. The u-blox CellularModule should be used in such a manner such that the potential for human contact duringnormal operation is minimized.This device has been evaluated and shown compliant with the IC RF Exposure limits undermobile exposure conditions (antennas are greater than 20 cm from a person's body).This device has been certified for use in Canada. Status of the listing in the Industry Canada’sREL (Radio Equipment List) can be found at the following web address:http://www.ic.gc.ca/app/sitt/reltel/srch/nwRdSrch.do?lang=engAdditional Canadian information on RF exposure also can be found at the following webaddress: http://www.ic.gc.ca/eic/site/smt-gst.nsf/eng/sf08792.html