Lamtec ETAMATIC S manuals
ETAMATIC S
Table of contents
- Table Of Contents
- Table Of Contents
- Table Of Contents
- Table Of Contents
- GENERAL INFORMATION
- Variants - Device Configuration
- SAFETY
- For Your Safety
- Associated Automatic Flame Guard
- BRIEF DESCRIPTION
- Display and operational controls
- OPERATING DESCRIPTION
- COMMISSIONING
- Character of the Output Channels
- Start with or without pilot burner
- Pre-ventilation period
- Deactivate load control unit
- Post-ventilation time
- Delaytime of the Air Dampers During Pre-ventilation
- Parameters of the Interface
- Set pilot burner (maintenance mode)
- Automatic Restart after Failure
- Burner Firing Rate Controller
- Setting
- Programming the Ignition Point
- Programming the 3rd up the 10th Point
- Fault
- O2-CONTROL
- How to Change the Password
- Automatic Function Monitoring During Operation
- Dynamic Probe Test
- Control Strategy
- Display and Interpretation of the Operating Modes
- Correction Type 2
- Calling up the Set Correction Mode
- Calling up Running Time Meter
- Re-enter Range Limits
- INTERNAL BURNER FIRING-RATE CONTROLLER
- Input Signals
- Control by Atmospheric Condition
- Start-up Sequence
- Thermostat and Control Range
- Manual Control
- Control Range
- CONTROL MODE
- Aides for Setting
- Leakage test
- Leakage test flow chart
- Calculation example
- Standby
- APPENDIX
- Flame Monitoring
- General Information of the Optical Flame Monitoring
- Optical flame sensors
- Error Codes
- Aides
- Calling Up the Condition of the Digital Inputs
- Tips and Tricks
- Process Sequence Charts
- Connection Diagrams
- Connection Examples Regular Firing Rate Input
- Connection flame monitor and external firing rate controller
- LAMTEC SYSTEM BUS (LSB)
- LAMTEC SYSTEM BUS Plug
- Modem for Remote Control
- Inernal Connecting Diagram of the Control Output Device
- Exhaust of test line over the roof
- Switch- and Key Combinations
- R. P. M. Sensor
- Selection of the Suitable R. P. M. Sensor
- External Switching of the fuel motors/ valves
- Feedback at Three-point-step Outputs
- Changing Control Drives / Potentiometers
- How to replace a potentiometer
- Wiring Notes
- Run to Shut-off Limits
- Tolerance Limit in Direction Air Deficiency
- Example of a Protocol of the Parameter Settings of the Monitoring Bands
- Technical Data
- ETAMATIC without internal flame monitoring
- declaration of conformity
ETAMATIC S
Table of contents
- Channel 1 OPEN
- Table Of Contents
- Table Of Contents
- Normen
- Geräte-Sicherheitsgesetz
- Ablaufbeschreibung ETAMATIC
- Start ohne Zündbrenner
- Übernahme
- O -Regler
- Display switching
- Bedienung und Anzeige O -Regelung
- Anzeige und Bedeutung der Betriebsmodi
- Betriebsstundenzähler abrufen
- Abrufen der Checksummen und Sicherheitszeiten
- Interner Leistungsregler
- Leistungsreglersollwert eingeben
- Thermostat und Regelbereich
- Handsteuerung
- Anhang
- Integrierte Flammenüberwachung
- Eigenüberwachungsprinzip
- Störcodes
- Hilfen
- Zustand der digitalen Eingänge abrufen
- Process sequence charts
- Ablaufdiagramme
- Technische Daten
- ETAMATIC without internal flame monitor
manualsdatabase
Your AI-powered manual search engine