Garmin GFC 500 manuals
GFC 500
Table of contents
- Table Of Contents
- Table Of Contents
- Table Of Contents
- Table Of Contents
- INTRODUCTION
- Definitions/Abbreviations
- Units of Measure
- Revision and Distribution
- SYSTEM DESCRIPTION
- GFC 500 Interface Summary
- Power Requirements
- Figure 2-3 – Electrical Bonding Preparation – Nut Plate
- Figure 2-5 – Electrical Bonding Preparation – Terminal Lug
- CONTROL AND OPERATION
- Servicing Information
- Maintenance Intervals
- Visual Inspection
- Electrical Bonding Test
- Disconnect Tone and Sonalert Test
- TROUBLESHOOTING
- GFC 500 Interconnect Drawings
- EQUIPMENT REMOVAL & INSTALLATION
- Figure 6-1 – GMC 507 Installation with rack
- GSA 28 Servos
- GFC 500 LRU REPLACEMENT/CONFIGURATION & TESTING
- GFC 500 SOFTWARE LOAD AND CONFIGURATION PROCEDURES
- GFC 500 RETURN TO SERVICE PROCEDURE
- Normal Mode Tests
GFC 500
Table of contents
- Table Of Contents
- Table Of Contents
- Section 1 – General
- ABBREVIATIONS AND TERMINOLOGY
- INSTALLED EQUIPMENT INTERFACES
- INSTALLED FEATURES CHECKLIST
- Section 2 – Limitations
- Section 3 – Emergency Procedures
- AUTOPILOT FAILURE / ABNORMAL DISCONNECT
- OVERSPEED PROTECTION (MAXSPD)
- Section 3A – Non-Normal Procedures
- LOSS OF AIRSPEED DATA
- HEADING DATA SOURCE FAILURE
- Section 4 – Normal Procedures
- VERTICAL MODES
- VERTICAL NAVIGATION (VNAV)
- GO AROUND
- LATERAL MODES
- NAVIGATION (GPS)
- APPROACHES
- LOC APPROACH (GS out)
- GPS APPROACH (LPV, LNAV/VNAV, LP+V, or LNAV+V)
- LOC BC APPROACH
- VOR APPROACH
- DISABLING ESP
- Section 5 – Performance
- Section 6 – Weight and Balance
- Section 7 – System Description
- AUTOPILOT CONTROL UNIT AND DISPLAY
- PREFLIGHT TEST
- LIGHTING
manualsdatabase
Your AI-powered manual search engine