Keysight Technologies M9371A manuals
M9371A
Table of contents
- Table Of Contents
- Table Of Contents
- Introduction
- STEP 1. Unpack and Inspect the Network Analyzer Modules
- Inspect for Damage
- STEP 2. Check the Shipment
- system requirements
- Power Up the Controller
- STEP 4. Install the Network Analyzer Modules
- Tools Required for the Installation Procedure
- Front Panel Features
- STEP 5. Verify Operation of the Network Analyzer Modules
- If the Operator's Check Fails
- Help System
- N937xA on the Internet
- Contacting Keysight
- Maintenance
- Shipment for Service
- Safety Symbols
- General Safety Considerations
- Regulatory Information
- Instrument Markings
- Declaration of Conformity
- Warranty
M9371A
Table of contents
- safety notices
- Table Of Contents
- Table Of Contents
- Information in This Chapter
- Maintenance
- Keysight Support, Services, and Assistance
- Error Terms
- Performing Measurement Calibration
- Accessing Error Terms
- Manual Access to Error Terms
- Error Term Data
- Option Enable Utility
- Changing a Serial Number
- Firmware Upgrades
- Before You Begin
- Verify the Operating Environment
- Allow the Analyzer to Warm Up
- About System Verification and Performance Tests
- Instrument Specifications
- Certificate of Calibration
- ANSI/NCSL Z540.3-2006 and ISO/IEC 17025 Verification
- Non-Standards Compliant Verification
- Preliminary Checks
- The Test Port Cable Checks
- System Verification
- Measurement Traceability
- Performing System Verification
- Performance Tests
- Source Power Accuracy Test
- Source Maximum Power Output Test
- Source Power Linearity Test
- Frequency Accuracy Test
- Trace Noise Test
- Receiver Compression Test
- Noise Floor Test
- Calibration Coefficients Test
- Dynamic Accuracy Test
- Adjustments
- Source Adjustment
- Receiver Adjustment
- Troubleshooting
- Replaceable Parts
- Connector Replacement Procedure
- Replacement Procedure
M9371A
Table of contents
- Table Of Contents
- B. Select Controller (Embedded Controller)
- C. Select Controller (Via PC)
- D. Select a Chassis and Accessories
- E. Physical Connection Diagram for Controllers
- F. Select Software for M937xA PXIe VNA
- G. Select Services: Calibration, Start-up Assistance
- H. Measurement Accessories
- For devices with 3.5 mm or SMA connectors
- For devices with Type-N connectors
- For devices with 7 mm connectors
- I. Example Configurations
- Multi-site Measurement Configurations
- Using a Non-Keysight Chassis
manualsdatabase
Your AI-powered manual search engine