Advantech PCM-4825 manuals
PCM-4825
Table of contents
- copyright notice
- packing list
- Table Of Contents
- Table Of Contents
- Table Of Contents
- Table Of Contents
- Chapter 1 General Information
- Introduction
- Features
- Specifications
- Local-bus flat panel/VGA interface
- Board layout and dimensions
- Chapter 2 Installation
- Jumpers and connectors
- Locating jumpers
- Locating connectors
- Setting jumpers
- PCM-4825 Jumper Settings
- Safety precautions
- Installing DRAM (SIMMs)
- IDE hard drive connector (CN7)
- Keyboard and PS/2 connector (CN14)
- Audio connector (CN11)
- Serial ports (CN13, CN9)
- VGA interface connections
- Chapter 3 Software Configuration
- VGA display software configuration
- Connections for four standard LCDs
- Chapter 4 Award BIOS Setup
- System test and initialization
- Award BIOS setup
- Standard CMOS setup
- BIOS features setup
- CHIPSET features setup
- Power management setup
- Load BIOS defaults
- Load setup defaults
- Change password
- Security option
- Auto detect hard disk
- Chapter 5 SVGA Setup
- Before you begin
- Installation
- Driver installation (Windows 3.1 & DOS)
- DOS setup
- Windows 95 drivers setup procedure
- Step 3
- Selecting monitor type
- Selecting screen resolution/refresh rate
- Installation notes
- Chapter 6 Audio Setup
- Controlling volume in DOS
- Driver installation
- Windows 95 drivers
- A.1 CRT display connector (CN15)
- Appendix A Pin Assignments
- A. 5 Main power connector (CN12)
- A.7 COM1 RS-232 serial port (CN13)
- A.9 Peripheral power connector (CN1)
- A.11 Parallel port connector (CN4)
- A.13 IR connector (CN8)
- A.14 System I/O ports
- A.15 DMA channel assignments
- A.17 1st MB memory map
- B.1 Installing PC/104 modules
- Appendix B Installing PC/104 Modules
- Appendix C DOC 2000 Installation Guide
- C.1.1 DiskOnChip 2000 installation instructions
- C.1.2 Additional information and assistance
manualsdatabase
Your AI-powered manual search engine