Chapter 5 SVGA Setup 495.7.3 Step 31.Upon restarting your computer, select the desired display settingsfrom the Display property dialog box.2.Click on Test to test the newly selected graphics mode. A colortest screen should appear, followed by the Testing Mode window.3.Click on Yes to continue. Click on Apply to switch to the newgraphics mode.4.Since graphics modes are changed dynamically with NT 4.0, youneed not shutdown and restart to give effect to the new screensettings.5.8 OS/2 drivers setup procedure5.8.1 Preliminary stepsThe following steps must be performed before you install the65550/554 display driver:1. OS/2 DOS support must be installed.2. If you previously installed SVGA support, you must reset thesystem to VGA mode. VGA is the default video mode enabledwhen OS/2 is installed.To restore VGA mode, use Selective Install and select VGA forPrimary Display. For more information on this procedure, see thesection on Changing Display Adapter Support in the OS/2 User'sGuide.5.8.2 Installing from disketteTo install this driver, do the following steps:1. Open an OS/2 full screen or window session.2. Place the 65550 Display Driver Diskette in drive A.3. At the OS/2 command prompt, type the following commands tocopy the files to the OS/2 drive:
