56 PCM-4825/4845L User's Manual6.3 Driver installation6.3.1 Before you beginTo facilitate the installation of the audio drivers, you should readthe instructions in this chapter carefully before you attemptinstallation. The audio drivers for the PCM-4825/4825L board arelocated on the audio driver diskettes. You must install the driversby using the supplied SETUP program.Note: The files on the software installation diskette arecompressed. Do not attempt to install the driversby copying the files manually. You must use thesupplied SETUP program to install the drivers.6.3.2 Windows 3.1 driversThese drivers are designed to work with Microsoft Windows 3.1.You may install these drivers through Windows.1. Run Windows to make sure that it is working correctly.2. Place the audio driver diskette in drive A. In the WindowsProgram Manager, choose File from the Options Menu. Thenfrom the pull-down menu, choose Run . . . . At the command lineprompt, type A:\WIN31\SETUP. Press the key or clickOK to begin the installation.3. Click Continue when the “AudioDrive Setup” screen shows up.Click the Driver Installation button to choose installing theaudio driver.4. At this point, the setup program displays the “Set HardwareSetting” screen, which allows you to change the hardwaresetting of the audio controller in Windows. For proper operation,make sure the address, IRQ, and DMA settings are not used byother hardware. Press the key or click OK to completethe installation.Once completed, you can change the settings or remove the audiodriver by using the Windows’s Control Panel program.
