2gig Technologies Go Control Install Manual

Also see for Go Control: Quick guide

Contents

2gig Technologies Go Control Install Manual Manual pdf 40 page image

RF Key Fob Programming Steps©2013 2GIG Technologies Inc. All Rights Reserved. 39Select Fob (3) key 2 can disarm (0-1)Default: Enabled (1)As an installer, consult the user as to whether to setthe Key Fob to allow disarming the Control Panelwith the Key Fob’s button. If the user wants theKey Fob used as a stationary wall Fob, it can also beset to prevent using the Key Fob to disarm thesystem.• The default (1) allows the Fob to disarm thesystem.• To not allow the Fob to disarm the system,select disabled (0).Construct Fob (#) voice descriptorDEFAULT: Keyfob (#)The voice descriptor are the actual the words thatthe Control Panel use for this Fob for low batteryannouncements and log entries. Up to five wordsare allowed.1 Press Insert to place a word from thevocabulary into the data entry field.2 Use the ← or → arrows to scroll through thewords, or enter the word’s 3‐digit indexnumber.3 Press Insert again for the next word. Up to fivewords are allowed.4 To remove a word, press Delete.Select Fob (#) arm no delay (0-1)DEFAULT: Disabled (0)Key fobs can be set to arm the Control Panel withor without an Entry Delay.• The default (0) sets this Fob to arm the systemwith an Entry Delay.• To set this Fob to arm the system without anEntry Delay, select enabled (1).Select Fob (#) key 4 output (0-2)DEFAULT: Disabled (0)The Key Fob’s auxiliary button can be used totrigger the Control Panel’s open collector output.The default (0) disables this Fob’s auxiliary button.To use this Fob’s auxiliary button, select the outputfunction:• (0) disabled• (1) toggle output• (2) momentary outputRF KEYPAD PROGRAMMINGThe Control Panel can be programmed with up to 4RF remote control keypads or wireless touch screen(TS‐1) keypads.NOTE: RF Keypads 1 ‐ 4 report to the ControlPanel as sensors 59 ‐ 62 (for emergency,and low battery reports).RF Keypad Reporting CodesRF Keypad #1 Reports as sensor #59RF Keypad #2 Reports as sensor #60RF Keypad #3 Reports as sensor #61RF Keypad #4 Reports as sensor #62• User Codes #1 ‐ #8 are reported for openingsand closings• User Code #0 is reported for Quick ArmingThe following options can be set for each RFRemote Control Keypad:RF Keypad Number — Keypad number 1‐4Q-4 Sub-Questions:• RF Keypad Used — Keypad used or not• RF Keypad Equipment Code — Sensormodel• RF Keypad Other Equipment Code —Enter special equipment code (onlyshown for sensors set as “other”)• RF Keypad Serial # — Serial numberlabeled on keypad; manually enter or“learn” by sending signal• RF Keypad Equipment Age — New unit orexisting keypad• RF Keypad Emergency Keys — Enable ordisable Keypad emergency keys• RF Keypad Voice Descriptor — Nameassigned to the KeypadRF Keypad Summary ScreenAfter setting all the options for a sensor, the RFkeypad summary screen is displayed. The screencan also be displayed for programmed RF keypadsby pressing the Sum button.• To return to programming, click the editcurrent or edit next buttons.• Pressing skip goes to question Q‐5 (ControlPanel programming).• To exit programming, click skip then end andexit. Upon exit, the Control Panel takes aseveral seconds to reboot.