2gig Technologies Go Control Install Manual

Also see for Go Control: Quick guide

Contents

2gig Technologies Go Control Install Manual Manual pdf 58 page image

Final Installation Setup©2013 2GIG Technologies Inc. All Rights Reserved. 5710 To set the calendar and the clock press SetDate and Set Time.On the Set Date screen, use the ↓ and ↑arrows to set the month, day, and year. On theSet Time screen, use the ↓ and ↑ arrows toset the hours, minutes, and AM/PM. Whendone, press Ok. A confirmation screenappears. Verify the time and date, then pressOk again.11 If the cell radio module is installed andregistered, the date and time is setautomatically.• To return to the Security Screen, press BackOR• To return to the Home Screen, press thebutton.INSTALLER TESTINGTesting the SystemAfter the installation is complete and the ControlPanel programming is complete, the system mustbe tested to ensure proper operation.System testing is performed through the InstallerToolbox screen.1 Press the lower right corner of the Homescreen.2 To access the Installer Toolbox, enter theInstaller Code (default = 1561).Sounder Disable/EnableBecause testing causes the Control Panel’s internaland external alarm sounder to activate, an optionto lower the sounder is available.1 From the Installer Toolbox Screen, pressDisable Sounder.2 A confirmation screen appears. Press Ok. Fourbeeps will sound from the internal sounder,and a short siren will sound from the externalsounder. The external siren will be disabledand the internal sounder will be lowered for30 minutes.3 A second confirmation screen appears toverify that the test sounds occurred. Press Ok.4 While the sounder is disabled, the SounderDisable Icon appears on the status bar.5 The Sounder Disable automatically times outafter 30 minutes, and the sounderautomatically becomes active again.To re‐enable the sounder manually, follow thesesteps:1 From the Installer Toolbox Screen, pressEnable Sounder.2 A confirmation screen appears. Press Ok.Zone Reporting TestTo verify that the Central Station correctly receivesreports from each zone (sensor type), do thefollowing tests:1 Inform the Central Station that test signals willbe sent.2 Trigger a 24‐hour fire sensor (if installed) orpress the Fire emergency button (if enabled),wait about 45 seconds for the report tocomplete, then disarm the Console.