2gig Technologies Go Control Install Manual

Also see for Go Control: Quick guide

Contents

2gig Technologies Go Control Install Manual Manual pdf 57 page image

56 ©2013 2GIG Technologies Inc. All Rights Reserved.FINAL INSTALLATION SETUPEXITING PROGRAMMING(SYSTEM CONFIGURATION)After programming the Control Panel, all thechanges need to be saved in memory. After saving,the programmed settings will remain in memory,even after a total power loss.1 After setting all the required programmingvalues for the sensors and the Control Panel,press End.2 Review the Summary of System ConfigurationScreen. Use the ↓ and ↑ arrows to scrollthrough the listing. Verify that each option isset correctly.3 To save the programming changes, be sure theSave Changes option is checked. To exitwithout saving programming changes un‐check the Save Changes option (forverification, an additional confirmation screenappears). Press Exit.4 The Control Panel takes a few seconds torestart and display the Home Screen.Customizing the InstallationAfter programming the Control Panel, go to theUser Toolbox and customize the system to suit theinstallation. To access the User Toolbox, do thefollowing:1 From the Home Screen, press Security.2 From the Security Screen, press, Menu.3 From the Menu Screen, Press Toolbox.4 Enter the Master User Code (default = 1111).5 Press User Management.6 To add, change, or delete a User Code, press aUser button. The system asks to confirm thecode entered. Be sure to set a Duress Code asUser #8.NOTE: User codes 0000, 0001, and theInstaller Code are not permitted.7 Setup each User Code with the User AccessOption Screen. Each User Code can be set tobe currently valid or not, or to haveconditional validity. Refer to the User Guide fordetails on setting User Code Access Schedules.When done, press Back.8 Press Brightness/Volume. Set the level for thedisplay brightness. Set the chime & voicevolume. When done, press Ok.9 To view the 2nd Toolbox Screen, press →. Toset the display lighting timeout, press BackLight Timeout. Choose the length of time thatthe display will remain lit after it is idle. Whendone, press Ok.