3Com 3500 Manual

Also see for 3105 ATTENDANT CONSOLE: Reference guide User guide User guide User guide User guide

Contents

3Com 3500 Manual Manual pdf 35 page image

324 To clear the display, press the OK button.Activating Do Not DisturbWhen you enable Do Not Disturb, incoming calls immediately go to the call coveragepoint set by you or your administrator. The default call coverage point is your voicemailbox. The call coverage point is set through the VCX User Interface (see Chapter 6).When your telephone is in Do Not Disturb mode: An incoming call does not cause your telephone to ring. If you are logged in tomultiple telephones using the same telephone number and one of the telephonesenables Do Not Disturb, the feature applies to all telephones—an incoming call willnot ring on any of the telephones. You can use the telephone to dial outgoing calls. If you enable Do Not Disturb, the pending calls are sent to your call coverage pointand Do Not Disturb is enabled for all subsequent calls. If you are a Hunt Group or ACD group member and you enable Do Not Disturb,personal (non-Hunt Group) calls go to your call coverage point. However, HuntGroup or ACD group calls always ring on a member’s telephone, regardless of the DoNot Disturb setting.If your telephone is part of a bridged extension, see Do Not Disturb and Bridged LineCalls for additional information.To activate Do Not Disturb:1 Press the Do Not Disturb Access button on the telephone. The white light is lit next tothe Do Not Disturb button.Your telephone is now in Do Not Disturb mode. The Display Panel shows Do NotDisturb.2 To disable Do Not Disturb mode, repeat step 1. The DND message disappears from theDisplay Panel and the white light goes out.Activating Malicious Call TraceThe Malicious Call Trace feature enables you to notify the system if you receive aharassing or abusive call. The calling party can be from either an external or internalsource.Malicious Call Trace cannot be invoked when you are on a conference call.To activate malicious call tracing during a call, press Feature + 6 + 119.The Display Panel shows malicious call for 5 seconds.The results of tracing a malicious call include the following actions: Notification is sent to your network manager. The log for the call includes a malicious call identifier. For external malicious calls, the VCX system sends a message to the authoritiesconfigured by your administrator to receive these reports.