3Com 3C3FE574BT User Manual
Also see for 3C3FE574BT: Quick start guide
                                              | |
Contents
| 
4 SETUP FOR WINDOWS NTInserting the PC Cardand Running theInstallation1 Either print this page or write down the following seven steps.2 Log out of Windows and turn the computer off.3 Insert the PC Card into the PC Card slot.4 Connect the PC Card to the network as shown in Chapter 55 Turn your computer on and log in to Windows.6 Insert the CD into the CD-ROM slot. The auto-start feature will start the PC Cardinstallation. If auto-start is disabled on your computer, click Start>Run and typed:\setup.exe (where d: is your CD-ROM drive).7 Select Install PC Card. This page will appear.8 Select the appropriate subsection and follow the instructions to install the networkdrivers.Installation UsingSoftex SoftwareUse the following procedures if the Softex PC Card Controller for Windows NT 4.0is installed on your system. If the Softex software is not installed, use theprocedures for “Installation Using Point Enabler” on page 14.For the following procedures: The computer must be running Windows NT 4.0. The Softex PC Card Controller for Windows NT 4.0 must be installed. Windows NT Service Pack 3 or later must be installed.If you are reinstalling the card, make sure you have completed the proceduresfor “Uninstalling the Card” on page 16. For Windows NT 4.0 installation, youmust have Service Pack 3 or later installed on your computer. After installation,reinstall the Service Pack software to update NT network files and eliminateerror messages in the Event Viewer. Contact your Network Administrator orMicrosoft if you do not have the current Service Pack. |
Related manuals for 3Com 3C3FE574BT
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine