Connecting the Remote Wake-Up Cable193 Plug the RJ-45 connector on the twisted-pair network cable into the RJ-45 port on theNIC backplate as shown in the figure.4 Connect the other end of the network cable to an active network port.The next step is to install the software, as described in “Installing Software” on page 20.Connecting the Remote Wake-Up CableThis section describes how to connect the Remote Wake-Up cable from the NIC to the PCmotherboard. Connecting the Remote Wake-Up cable is optional. Connect this cable onlyif your NIC supports Remote Wake-Up and you want to use this feature.NOTE: If you are installing multiple 3Com 10/100 PCI NICs in one computerrunning Windows, see the instructions in “Installing Multiple NICs” on page 31. Ifyou are installing multiple 3Com 10/100 PCI NICs in one computer runningNetWare, follow the instructions in “Installing Multiple Server NICs” on page 61.NOTE: If your site network installation procedures require you to verify thatinstalled hardware is functional before you install software, run the3C99XCFG.EXE DOS diagnostics program before installing the driver. Thisprogram is located on the 3Com EtherCD. For more information, see “Using the3Com DOS Configuration Program” on page 77.ACTSTATUSWARNING: Make sure that the PC power cord is unplugged. Only properlytrained and authorized personnel should perform service. Contact your PCmanufacturer for information about safe service techniques.NOTE: If your PC is compliant with PCI 2.2, Remote Wake-Up is automatically enabledthrough the PCI bus. You do not need to connect the Remote Wake-Up cable.
