Maintaining Groups71retry countThis command sets the number of retries that the software attempts when a probe packetfails to appear at the receive end. After the retries, the software puts the board in Waitmode. If no argument is specified or the specified argument is invalid, the current value isdisplayed. Otherwise, the new value is displayed.send timeoutThis command sets the timeout value, in seconds, that the software waits beforeretransmitting a probe packet when a send request to the link support layer (LSL) is notacknowledged. A message is displayed for each loaded frame type.ungroupThis command deletes a group. The LAN driver for the group must not be loaded. Thefollowing message appears for all frame types that the NIC supports:Cleaning up resources for group associated with Primary Slot#xxxx.Syntax lbrsl retry count number_of_retrieswhere:number_of_retries is any positive integerExample lbrsl retry count 2Default 5Syntax lbrsl send timeout pri_slot secondswhere:pri_slot is the PCI slot number of the primary NIC.seconds is the time in seconds.Example lbrsl send timeout 1001 10Default 10Syntax lbrsl ungroup pri_slotwhere:pri_slot is the PCI slot number of the primary NIC.Example lbrsl ungroup 10001Default None
