36 CHAPTER 3: QUICK SETUP FOR THE F IREWALLThe process followed by the Installation Wizard is described in thefollowing sections: Configuring Basic Settings Configuring WAN Settings Configuring LAN Settings Confirming Firewall SettingsSetting up aManagementStationThe Firewall has the following default settings: IP address — 192.168.1.254 Subnet mask — 255.255.255.0To access the Installation Wizard you must configure a computer to be inthe same subnet. This computer will be referred to as a ManagementStation.Follow the steps below to configure a computer as a ManagementStation:1 Note the IP address and subnet mask of the Management Station. Youwill need to return your Management Station to these settings when youhave finished using the Installation Wizard.2 Change the IP address to a value within the Firewall’s default subnet. Thiswill be a value between 192.168.1.1 and 192.168.1.254 but not192.168.1.254 as this is already taken by the Firewall. A suitable addresswould be 192.168.1.20 if this is not already taken by another device.3 Enter http://192.168.1.254/ (the Firewall’s default IP address) into thebox at the top of the browser window. The Installation Wizard isdisplayed on screen and will guide you through the configurationdescribed in the sections below.4 Remember to change the IP address and subnet mask of youManagement Station back to their original values when you have finishedconfiguring the Firewall using the Installation Wizard.Configuring BasicSettingsWhen the Installation Wizard first starts it displays a welcome screenshown in Figure 7 below.DUA1611-0AAA02.book Page 36 Thursday, August 2, 2001 4:01 PM