Installing an Upgrade License 39To configure an enable password:1 If you are not already at the enabled access level, enter the enablecommand.WX1200> enable2 At the enabled prompt, enter set enablepass.WX1200# set enablepass3 When you are prompted for your old password, press Enter.Enter old password:4 When you are prompted for a new password, enter an enable passwordof up to 32 alphanumeric characters, with no spaces.Enter new password:The password you enter is not displayed.5 When you are prompted to retype your password, reenter the enablepassword.Retype new password:MSS does not display your password, but lets you know that the enablepassword is set:success: password changed(For information about additional ways to secure CLI access, see theWireless LAN Switch and Controller Configuration Guide.)Installing anUpgrade LicenseTable 10 lists how many MAPs you can configure on a WX switch, andhow many MAPs a switch can boot. The numbers are for directlyconnected and Distributed MAPs combined.You can install one or more upgrade licences to increase the number ofMAPs a WX4400 can boot. Each upgrade license adds support for anTable 10 Maximum MAPs Supported Per SwitchWX Switch ModelMaximumConfigured Maximum BootedWX4400 256 24, 48, 72, or 96,depending on thelicense.WX1200 30 12
