1-8The port state change delay takes effect when the port goes down but not when the port goes up.Follow these steps to set the port state change delay:To do … Use the command … RemarksEnter system view system-view —Enter Ethernet interfaceviewinterface interface-typeinterface-number —Set the port state changedelay link-delay delay-timeRequiredDefaults to 0, which indicates that nodelay is introduced.The delay configured in this way does not take effect for ports in DLDP down state. For informationabout the DLDP down state, refer to DLDP.Displaying and Maintaining Basic Port ConfigurationTo do... Use the command... RemarksDisplay port configurationinformationdisplay interface [ interface-type |interface-type interface-number ]Display the enable/disablestatus of port loopbackdetectiondisplay loopback-detectionDisplay brief information aboutport configurationdisplay brief interface [ interface-type[ interface-number ] ] [ | { begin | include |exclude } regular-expression ]Display port information abouta specified unit display unit unit-id interfaceDisplay the Combo ports andthe correspondingoptical/electrical portsdisplay port comboDisplay the information aboutthe port with the link-delaycommand configureddisplay link-delayAvailable in anyview
