1-7To do... Use the command... RemarksSpecify the supportedprotocol(s) protocol inbound { all |ssh }OptionalBy default, both Telnet andSSH are supported.z If you have configured a user interface to support SSH protocol, you must configure AAAauthentication for the user interface by using the authentication-mode scheme command toensure successful login.z On a user interface, if the authentication-mode password or authentication-mode nonecommand has been executed, the protocol inbound ssh command is not available. Similarly, ifthe protocol inbound ssh command has been executed, the authentication-mode passwordand authentication-mode none commands are not available.Configuring the SSH Management FunctionsThe SSH server provides a number of management functions to prevent illegal operations such asmalicious password guess, guaranteeing the security of SSH connections. You can specify the IPaddress or the interface corresponding to the IP address for the SSH server to provide SSH accessservices for clients. In this way, the SSH client accesses the SSH server only using the specified IPaddress. This increases the service manageability when the SSH server has multiple interfaces and IPaddresses.Follow these steps to configure SSH management functions:To do... Use the command... RemarksEnter system view system-view —Set the SSH authenticationtimeout time ssh server timeout secondsOptionalBy default, the SSHauthentication timeout time is 60seconds.Set the number of SSHauthentication retry attemptsssh serverauthentication-retries timesOptionalBy default, the number of SSHauthentication retry attempts is 3.Configure a login header header shell textOptionalBy default, no login header isconfigured.Specify a source IP address forthe SSH serverssh-server source-ipip-addressOptionalBy default, no source IP addressis configured.Specify a source interface forthe SSH serverssh-server source-interfaceinterface-typeinterface-numberOptionalBy default, no source interface isconfigured.