1-29To do... Use the command... RemarksEnter system view system-view —Enable MSTP stp enable RequiredMSTP is enabled globally by default.Enter Ethernet port view interface interface-typeinterface-number —Disable MSTP on theport stp disableOptionalBy default, MSTP is enabled on all ports.To enable a switch to operate moreflexibly, you can disable MSTP onspecific ports. As MSTP-disabled portsdo not participate in spanning treecalculation, this operation saves CPUresources of the switch.Other MSTP-related settings can take effect only after MSTP is enabled on the switch.Configuration example# Disable MSTP on Ethernet 1/0/1.1) Perform this configuration in system view system-view[Sysname] stp interface Ethernet 1/0/1 disable2) Perform this configuration in Ethernet port view system-view[Sysname] interface Ethernet 1/0/1[Sysname-Ethernet1/0/1] stp disableConfiguring Leaf NodesConfiguring the MST RegionRefer to Configuring an MST Region.Configuring How a Port Recognizes and Sends MSTP PacketsRefer to Configuring How a Port Recognizes and Sends MSTP Packets.Configuring the Timeout Time FactorRefer to Configuring the Timeout Time Factor.Configuring the Maximum Transmitting Rate on the Current PortRefer to Configuring the Maximum Transmitting Rate on the Current Port.Configuring a Port as an Edge PortRefer to Configuring the Current Port as an Edge Port.