1-7To do… Use the command… RemarksEnter system view system-view —Create a VLAN and enter VLANview vlan vlan-id vlan-id is the ID of theremote-probe VLAN.Configure the current VLAN asa remote-probe VLAN remote-probe vlan enable RequiredReturn to system view quit —Enter the view of the Ethernetport connecting to the sourceswitch or an intermediateswitchinterface interface-typeinterface-number —Configure the current port astrunk port port link-type trunkRequiredBy default, the port type isAccess.Configure trunk port to permitpackets from the remote-probeVLANport trunk permit vlanremote-probe-vlan-id RequiredReturn to system view quit —Create a remote destinationmirroring groupmirroring-group group-idremote-destination RequiredConfigure the destination portfor the remote destinationmirroring groupmirroring-group group-idmonitor-port monitor-port RequiredConfigure the remote-probeVLAN for the remotedestination mirroring groupmirroring-group group-idremote-probe vlanremote-probe-vlan-idRequiredWhen configuring a destination switch, note that:z A Switch 4500 acting as the destination switch in remote port mirroring networking does notsupport bidirectional packet mirroring (the both keyword).z The destination port of remote port mirroring cannot be a member port of an existing mirroringgroup, a fabric port, a member port of an aggregation group, or a port enabled with LACP or STP.z Only an existing static VLAN can be configured as the remote-probe VLAN. To remove aremote-probe VLAN, you need to restore it to a normal VLAN first. A remote port mirroring groupgets invalid if the corresponding remote port mirroring VLAN is removed.Displaying and Maintaining Port MirroringTo do… Use the command… RemarksDisplay port mirroring configurationon a Switch 4500display mirroring-group{ group-id | all | local |remote-destination |remote-source }Available in any view
