1-8You need to enable LACP on the ports which you want to participate in dynamic aggregation of thesystem, because, only when LACP is enabled on those ports at both ends, can the two parties reachagreement in adding/removing ports to/from dynamic aggregation groups.You cannot enable LACP on a port which is already in a manual aggregation group.Follow these steps to configure a dynamic LACP aggregation group:To do… Use the command… RemarksEnter system view system-view —Configure the system priority lacp system-prioritysystem-priorityOptionalBy default, the system priority is32,768.Enter Ethernet port view interface interface-typeinterface-number —Enable LACP on the port lacp enableRequiredBy default, LACP is disabled on aport.Configure the port priority lacp port-priorityport-priorityOptionalBy default, the port priority is32,768.Changing the system priority may affect the priority relationship between the aggregation peers, andthus affect the selected/unselected status of member ports in the dynamic aggregation group.Configuring a Description for an Aggregation GroupTo do… Use the command… RemarksEnter system view system-view —Configure a description for anaggregation grouplink-aggregation group agg-iddescription agg-nameOptionalBy default, no description isconfigured for an aggregationgroup.