3Com 5500G-EI Command Reference Manual

Also see for Switch 5500G-EI PWR 48-Port: Product guide Product guide Specifications Product guide Configuration guide

Contents

NTP Configuration Commands 501NTP ConfigurationCommandsThis section describes the Network Time Protocol (NTP) configuration commandsavailable on your Switch 5500G-EI.debugging ntp-service Syntaxdebugging ntp-service { access | adjustment | authentication | event| filter | packet | parameter | refclock | selection |synchronization | validity | all }undo debugging ntp-service { access | adjustment | authentication |event | filter | packet | parameter | refclock | selection |synchronization | validity | all }ViewUser view.Parameteraccess: NTP access control debugging.adjustment: NTP clock adjustment debugging.all: All NTP debugging functions.authentication: NTP authentication debugging.event: NTP event debugging.filter: NTP filter information debugging.packet: NTP packet debugging.parameter: NTP clock parameter debugging.refclock: NTP reference clock debugging.selection: NTP clock selection information debugging.synchronization: NTP clock synchronization information debugging.validity: NTP remote host validity debuggingDescriptionUse the debugging ntp-service command to debug different NTP services. Usethe undo debugging ntp-service command to disable correspondingdebugging function.By default, no debugging function is enabled.ExampleEnable NTP access control debugging.debugging ntp-service access