Accessing the Host 9-3Other Remote-AccessCommandsThe table below is a list of remote-access configuration commands.Example: Sending AT%P1= will erase the view and change password.WARNING: If you erase the%P1 password without disabling remoteaccess (using ATS41=0), anyone could access the Business Modem andchange its configuration.Accessing the HostAt the Guest Device The guest device requires no configuration to access the host. Followthese steps:1 Be sure that the host device has enabled remote access and is set toauto-answer (ATS0=1). Know the password, if you will need one.2 Call the host device (although it doesn’t matter which device originatesthe call).3 After a connection is established, do this:a Pause 4 seconds.b Type 4 tildes: ~~~~c Pause 4 seconds.The administrator of the host device can change the remote-accesscharacter using S-Register 42, and the pause duration using S-Register43. See Appendix A, S-Registers for more information.For your modem to CommandDisplay a view-only password AT%P0?Display a view-and-change password AT%P1?Erase a view-only password AT%P0=Erase a view-and-change password AT%P1=Disable remote access entirely ATS41=0
