Accessing the Host 9-5Depending on your access privileges, you can use the regular set ofBusiness Modem AT commands.CAUTION: Be careful not to send ATZ or ATZ! or you will lose theconnection!RemoteConfigurationCommandsThere are special commands that can be used only during aremote-access session.You can change the host Business Modem’s serial port rate by using theAT%Bn command.Example: Sending AT%B6 will change the Business Modem’s serial portrate to 9600 bps.If you have this access privilege You can useView-only Any of the inquiry (ATI) commandsView and Configure Any of the Business Modem commands,except those that cannot be used whileonline (for example, ATD or ATA). You canalso use remote configuration commands.See the next section for examples.To change the hostBusiness Modem’sserial port rate to CommandTo change the hostBusiness Modem’sserial port rate to Command110 bps AT%B0 9600 bps AT%B6300 bps AT%B1 19200 bps AT%B7600 bps AT%B2 38400 bps AT%B81200 bps AT%B3 57600 bps AT%B92400 bps AT%B4 115200 bps AT%B104800 bps AT%B5
