Using SFP Transceivers 19Figure 3 Connecting Devices to the SwitchTo connect a device to the Switch:1 Connect one end of the cable to an RJ-45 port on theSwitch.2 Connect the other end to the appropriate RJ-45 porton the connecting device.For 1000BASE-T operation, 3Com recommends usingCategory 5e or 6 cables.Using SFP TransceiversThe following sections describe how to insert andremove an SFP transceiver from an SFP slot.SFP transceivers are hot-insertable and hot-swappa-ble. You can remove them from and insert them intoany SFP port without having to power off the Switch.Approved SFP TransceiversThe following list of approved SFP transceivers is cor-rect at the time of publication:■ 3CSFP91 SFP (SX)■ 3CSFP92 SFP (LX)To access the latest list of approved SFP transceiversfor the Switch on the 3Com Corporation World WideWeb site, enter this URL into your Internet browser:http://www.3com.com3Com recommends using 3Com SFPs on the Switch.If you insert an SFP transceiver that is not supported,the Switch will not recognize it.Inserting an SFP TransceiverTo be recognized as valid, the SFP transceiver must beone of the following:■ 1000BASE-SX SFP transceiver – Use this transceiverto connect the Switch directly to a multimediafiber-optic cable.■ 1000BASE-LX SFP transceiver – Use this transceiverto connect the Switch directly to a single-modefiber-optic cable or to multimode fiber using a con-ditioned launch cable.If the SFP transceiver is faulty, it will not operatewithin the Switch. See “Troubleshooting” onpage 51.To insert an SFP transceiver:1 Hold the transceiver so that the fiber connector istoward you and the product label is visible, as shownBaseline 10/100 switch2 36547 8 9#0*12 36547 8 9#0*1Endstations on switched100 Mbps connectionsEndstations on switched100 Mbps connectionsBaseline 10/100 switchBaseline Switch 2226-PWR PlusPoE-compliant devices1000 Mbps link10 or 100 Mbps linkPoE linkServer on switched1000 MbpsconnectionEndstationson switched10 or 100 Mbpsconnection1000 Mbps copperor fiber connectionto backbone orserver/workstation