4 INSTALLING THE DUAL 56K LANMODEMThis chapter explains how to connect your computer to the Dual 56K LAN Modemand install the cables in preparation for configuring the unit.When you first set up the LAN Modem, you initially connect only one computer tothe unit. After you have finished configuring the LAN Modem from that computerusing a standard web browser, you can then begin to network additionalcomputers, hubs, and/or printers to the LAN Modem.Before You Start theInstallationBefore you install the Dual 56K LAN Modem, have the following items ready. Two analog (RJ-11 to RJ-11) telephone cables (provided). One 10BASE-T Ethernet cable (RJ-45 to RJ-45). It is recommended that you usethe cable provided. If, however, you choose to use another cable, it must be astraight-through, 10BASE-T Ethernet cable. A crossover cable cannot be usedto connect the LAN Modem to your computer. Power adapter (you must use the power adapter provided in the package).Installation Steps To install the Dual 56K LAN Modem:1 Turn off your computer.2 Connect your computer to any LAN port (if you are unsure, use Port 1), using theEthernet cable provided, as shown in Figure 25.Figure 25 Ethernet Cable Connection3 Connect the two analog cables to the ports labeled LINE 1 and LINE 2 on the Dual56K LAN Modem’s back panel, and insert the opposite ends into two availableanalog wall jacks, as shown in Figure 26.If you are only using one line, use the LINE 1port.LAN1324LINE 1 PHONE 1 LINE 2 PHONE 2RJ-45EthernetcableRJ-45
