6-3By default, no password is set for the switch and you can press Enter to enter the boot menu.While using the switch, keep in mind the modified Boot ROM password.BOOT MENU1: Download application file to device2: Select application file to boot3: Display all files in device4: Delete file from device5: Modify bootrom password0: RebootEnter your choice(0-5):Downloading Through the Management/Upgrade Ethernet Port Using TFTPIntroduction to TFTPTrivial File Transfer Protocol (TFTP) is a TCP/IP protocol used for file transmission between client andserver. TFTP provides the unreliable data stream transfer service over UDP.Downloading the host software package1) Connect the switch to the PC that stores the file to be downloaded through themanagement/upgrade Ethernet port (the IP address of the PC is required). Connect the switch to aPC through the console port (the two PCs can be the same one).2) Run the TFTP Server program on the PC connected to the Ethernet port, and specify the filedirectory of the program to be downloaded.3) Run the terminal emulation program on the PC connected to the console port. Start the switch,enter the boot menu (refer to section “BOOT Menu” on page 6-1), and enter 1 when the systemdisplays “Enter your choice(0-5):” to enter the download protocol menu:BOOT MENU1. Download application file to device2. Select application file to boot3. Display all files in device4. Delete file from device5. Modify bootrom password0. RebootEnter your choice(0-5): 14) On the download protocol menu, type 1 to select TFTP, and then press Enter to set the TFTPparameters:1. Set TFTP protocol parameter2. Set FTP protocol parameter
