B CHANGING CONFIGURATIONSETTINGSYou can change the 3C359B NIC’s configuration settingsthrough a DOS Configuration and Diagnostic Programprovided on TokenDisk diskette 1 and on the TokenLinkVelocity XL CD.This appendix provides configuration instructions.Instructions for testing the NIC with the diagnosticpart of the DOS Configuration and Diagnostic Programare located in Chapter 6, “Troubleshooting.”Using the Configuration ProgramBefore running the DOS Configuration and DiagnosticProgram, perform a clean DOS boot from a DOS diskette(or the hard drive’s DOS option, if provided) to ensurethat no memory managers or drivers are loaded. TheConfiguration and Diagnostic Program does not run ina DOS window called from another operating system.To change the configuration option settings for the3C359B NIC, follow these steps.1 If you are using the 3.5-inch TokenDisk diskettes,insert TokenDisk diskette 1 in the drive and makethat drive the active drive. For example, enter:a:If you are using the TokenLink Velocity XL CD (inDrive D for example), enter the following path:d:\disk_12 Enter:3pcidThe DOS Diagnostic and Configuration Program screenis displayed with the Test menu selected, as shown inFigure 27.
