Installing a NetWare Server Driver 53Instructions in this section are written for TokenDiskdiskettes. If you are using the TokenLink Velocity XL CD,substitute the appropriate path (using the \DISK_2designation at the start of the path) where required.1 At the Load LAN Driver menu, insert TokenDiskdiskette 2 into the drive.2 Press Insert to load an unlisted LAN driver, and thenfollow the prompts to specify the driver load path.3 At the next menu, enter the following path:a:\netware\nwserver\41x_5.0After a short delay, a menu appears, showing theTLNKPODI.LAN driver.4 Press Enter to select the TLNKPODI.LAN driver.5 When asked if you want to copy the driver (toSYS:SYSTEM), respond Yes.The next menu shows the parameters that can be usedwith the 3C359B token ring NIC driver.6 Press Enter to view a list of supported options for theselected parameter.Additional help for the parameter is also displayed in thelower text box. You can also find a description ofparameters and explanations earlier in this chapter in“Using the LOAD Command.”7 After you have made selections for all 3C359B NICdriver parameters, press F10 to save the parametersand load TLNKPODI.LAN. Then follow the prompts tocomplete the server installation.UNBIND and UNLOAD CommandsYou can use the UNBIND or UNLOAD commands to removea driver (or logical board). The commands have the formatshown below:unbind ipx tlnkpodi unload tlnkpodiThe UNBIND command requires only that you reenterthe BIND command, and does not affect the LOADcommand. You can selectively unbind a protocol for a
