34 C HAPTER 3: N OVELL N ETW ARE E NVIRONMENTSIf you experience problems using Intelligent Auto Install,see the next section, “Intelligent Auto InstallTroubleshooting.” If you cannot connect to the NetWareserver after running Intelligent Auto Install, see Chapter 6,“Troubleshooting.”Intelligent Auto Install TroubleshootingIf you experience problems when using the Intelligent AutoInstall program, display or print the COMSLINK.LOG file,which contains a log of the events that occurred duringthe Intelligent Auto Install program installation andconfiguration process.1 To display the file, enter the following DOScommand:type comslink.log | more2 To print the file, connect to a local printer and enter:copy comslink.log prnorprint comslink.logInstalling a DOS 16-Bit Client ManuallyIf you did not use the Intelligent Auto Install utility, followthese steps to install the DOS 16-bit client driver forNetWare:1 Insert the Novell NetWare Client for DOS andMicrosoft Windows Disk 1 and make that drive theactive drive. For example, enter:a:2 Enter the following command:installFollow the displayed instructions as they appear.3 When prompted to select the driver for your networkboard, scroll down through the list titled NetworkBoards. Select Other Drivers, and press Enter.4 If you are using the 3.5-inch TokenDisk diskettes,insert TokenDisk diskette 2 in the drive and makethat drive the active drive. For example, enter:a:
