48 CHAPTER 2: INSTALLATION SCRIPTS FOR A SINGLE PAIR OF S ERVERSSample UMSInstallation Script(Secondary Server)After the network installation script has been completed, the UMSinstallation script starts.UMS Installation Script — Secondary ServerType of VCX 7300 Installation (S-Standalone/C-Client/V-Server)? [S]Press the Enter or Return key to accept Standalone as the suggestedanswer.Number of voip ports? [144]Press the Enter or Return key to accept the default number (144) of VOIPports that the system will support. Do not enter a different value withoutconsulting 3Com.IP address of the outbound proxy? [10.20.30.43]Outbound Proxy is another name for the Call Processor. Enter the IPaddress of the primary VCX Call Processor.Name of the SIP DDD? [10.20.30.43]The SIP Default Dialing Domain software runs on the same server as theVCX Call Processor. Press the Enter or Return key to accept the IP addressof the primary VCX Call Processor.TCP/UDP Port on which the VCX 7300 will receive SIP messages [5060] 5060Press the Enter or Return key to accept 5060 as the suggested answer.The VCX Call Processor and UMS use the same port number but ondifferent IP addresses.IP address of the secondary proxy? (hit Enter if none) [ ] 10.20.30.41Enter the IP address of the secondary VCX Call Processor server(10.20.30.43 in this sample configuration that contains a single pair ofservers).Intelligent Mirroring configurationsShould Intelligent Mirroring be enabled (Y/N)? [N]: yAll supported UMS configurations require Intelligent Mirroring. Enter y.Enter the Device Name of the Network Card to be used by UMS? : eth0Enter the Device Name of the Second Network Card to be used by UMS, press ENTER ifonly one? :Press the Enter or Return key to indicate that UMS uses only the eth0network card.Name of the Remote Intelligent Mirrored system? [ ] vcx01Enter the name of the active UMS server (vcx01 in this example).
