608 CHAPTER 19: RF D ETECTION COMMANDSset rfdetectvendor-listAdds an entry to the permitted vendor list. The permitted vendor listspecifies the third-party AP or client vendors that are allowed on thenetwork. MSS does not list a device as a rogue or interfering device if thedevice’s OUI is in the permitted vendor list.Syntax — set rfdetect vendor-list {client | ap} mac-addr client | ap — Specifies whether the entry is for an AP brand or aclient brand. mac-addr — Organizationally Unique Identifier (OUI) to remove.Defaults — The permitted vendor list is empty by default and all vendorsare allowed. However, after you add an entry to the list, MSS allows onlythe devices whose OUIs are on the list.Access — Enabled.History —Introduced in MSS Version 4.0.Usage — The permitted vendor list applies only to the WX switch onwhich the list is configured. WX switches do not share permitted vendorlists.If you add a device that MSS has classified as a rogue to the permittedvendor list, but not to the ignore list, MSS can still classify the device as arogue. Adding an entry to the permitted vendor list merely indicates thatthe device is from an allowed vendor. However, to cause MSS to stopclassifying the device as a rogue, you must add the device’s MAC addressto the ignore list.Examples — The following command adds an entry for clients whoseMAC addresses start with aa:bb:cc:WX1200# set rfdetect vendor-list client aa:bb:cc:00:00:00success: MAC aa:bb:cc:00:00:00 is now in client vendor-list.The trailing 00:00:00 value is required.See Also clear rfdetect vendor-list on page 583 display rfdetect vendor-list on page 597
