reset port 85reset port Resets a port by toggling its link state and Power over Ethernet (PoE)state.Syntax — reset port port-list port-list — List of physical ports. MSS resets all the specified ports.Defaults — None.Access — Enabled.History — Introduced in MSS Version 3.0.Usage — The reset command disables the port’s link and PoE (ifapplicable) for at least 1 second, then reenables them. This behavior isuseful for forcing a MAP access point that is connected to two WXswitches to reboot over the link to the other switch.Examples — The following command resets port 5:WX1200# reset port 5See Also set port on page 87set dap Configures a Distributed MAP for a MAP access point that is indirectlyconnected to the WX switch through an intermediate Layer 2 or Layer 3network.Before configuring a Distributed MAP, you must use the setsystem countrycode command to set the IEEE 802.11 country-specificregulations on the WX switch. See “set system countrycode” on page 58.For a MAP that is directly connected to the WX switch, use the set porttype ap command to configure a MAP access port.Syntax — set dap dap-num serial-id serial-ID model{ap2750 | ap3750| ap7250 | ap8250 | ap8750 | mp-52 | mp-241 |mp-252 | mp-262 | mp-341 | mp-352 | mp-372 | mp-372-CN |mp-37-JP | mp-620} [radiotype {11a | 11b | 11g}]
