Windows NT®4.0 Installationwww.3ware.com 71Continue with Windows NT 4.0 installation1 When Setup is Inspecting Your Computer Hardware Config-uration is displayed, press F6 immediately.2 You will see a Windows NT 4.0 Setup display.3 Press S to specify that you will be installing an additional massstorage device. On the display that follows, select Other andpress Enter.Install the driver using the diskette1 You will be asked to insert a diskette into the floppy drive andpress Enter.2 Select the 3ware ATA RAID Controller from the display thatappears and press Enter again. Ensure the path to this driver iscorrect in Copy manufacturer’s files from: at the bottom of thebox. To do this, type A:\winnt3 After the driver is loaded from the diskette, you will receive themessage “Setup has recognized the following mass storagedevices in your computer:” The list will contain the 3ware ATARAID Controller. If not, check the hardware and restart thissoftware installation. Otherwise, press Enter.Partition device 0 to create a boot area1 Follow the displayed instructions for Windows NT 4.0 installa-tion as directed until the following message appears “The listbelow shows existing partitions and spaces available for creatingpartitions.”2 The partitions list should contain an entry for your EscaladeATA RAID Controller that resembles the following: 4111 MBDisk 0 at Id 0 on bus 0 on 3waregsm. If it does not include a3ware entry, check your hardware and restart the software instal-lation process.3 Create a partition in the unpartitioned space of device 0 forinstalling Windows NT 4.0. Keep in mind that the space avail-
