AEN Messageswww.3ware.com 217AEN Error Message Details001h Controller reset occurredThe 3ware RAID controller has detected a soft reset from the device driver. Ifthe 3ware RAID controller fails to respond to the device driver within areasonable amount of time, the device driver may issue a soft reset to the3ware RAID controller and retry the command packet.002h Degraded unitAn error has been encountered and the array is operating in degraded (non-redundant) mode. The user should replace the bad drive as soon as possibleand initiate a rebuild.Removing a drive from a redundant unit will cause this AEN immediately.003h Controller error occurredThe 3ware RAID controller has encountered an internal error. Please contactAMCC Customer Support as a replacement board may be required.004h Rebuild failedThe 3ware RAID controller was unable to complete a rebuild operation. Thiserror can be caused by drive errors on either the source or the destination ofthe rebuild. However, due to ATA drives’ ability to reallocate sectors on writeerrors, the rebuild failure is most likely caused by the source drive of therebuild detecting some sort of read error. The default operation of the 3wareRAID controller is to abort a rebuild if an error is encountered. If it is desiredto continue on error, you can set the Continue on Source Error During Rebuildpolicy for the unit on the Controller Settings page in 3DM.059h Battery capacity is below error level05Ah Battery is present05Bh Battery is not present05Ch Battery is weak05Dh Battery health check failed05Eh Cache synchronization completed05Fh Cache synchronization failed; some data lostTable 10: AEN Error Message SummaryValue Message
