Operating Instructions — Batches4500 Series of Instruments System User Guide64 of 138 RUO-IDV-05-0264-AIf an LC method is used, then before the run is started, make sure that there isenough solvent in the reservoirs for the primary flow rate for all of the sample runsand the maximum idle time.5. Select Leave Mass Spec on in Standby to keep the mass spectrometer runningafter analysis has been completed. This feature allows the heaters and gases tocontinue running, even after devices have entered idle state, so that the ion sourceand entrance to the mass spectrometer are kept free of contaminants.6. Select Fail Whole Batch in Case of Missing Vial to fail the entire batch when amissing vial is encountered. If this option is not selected, only the current sample willfail and the queue will continue to the next sample.Add Sets and Samples to a BatchA set can consist of a single sample or multiple samples.1. In the navigation bar, under Acquire, double-click Build Acquisition Batch.2. In the Sample tab, in the Set list, type a name.3. Click Add Set.4. Click Add Samples to add samples to the new set.5. In the Sample name section, in the Prefix field, type a name for the samples in thisset.Note: For more information about adding quantitation information to a batch, refer tothe Advanced User Guide.Figure 9-2 Batch Editor Dialog
