292 Parameters43.09 Brake resistorPmax contDefines the maximum continuous load of the brake resistorthat will eventually raise the resistor temperature to themaximum allowed value (= continuous heat dissipationcapacity of the resistor in kW) but not above it. The value isused in the resistor overload protection based on the thermalmodel. See parameter 43.06 Brake chopper enable and thedata sheet of the brake resistor used.0.00 kW0.00…10000.00 kWMaximum continuous load of the brake resistor. 1 = 1 kW43.10 Brake resistance Defines the resistance value of the brake resistor. The valueis used for the brake resistor protection based on the thermalmodel. See parameter 43.06 Brake chopper enable.0.0 ohm0.0…1000.0 ohm Brake resistor resistance value. 1 = 1 ohm43.11 Brake resistor faultlimitSelects the fault limit for the brake resistor protection basedon the thermal model. See parameter 43.06 Brake chopperenable. When the limit is exceeded, the drive trips on fault7183 BR excess temperature.The value is given in percent of the temperature the resistorreaches when loaded with the power defined by parameter43.09 Brake resistor Pmax cont.105%0…150% Brake resistor temperature fault limit. 1 = 1%43.12 Brake resistorwarning limitSelects the warning limit for the brake resistor protectionbased on the thermal model. See parameter 43.06 Brakechopper enable. When the limit is exceeded, the drivegenerates a A793 BR excess temperature warning.The value is given in percent of the temperature the resistorreaches when loaded with the power defined by parameter43.09 Brake resistor Pmax cont.95%0…150% Brake resistor temperature warning limit. 1 = 1%4444 Mechanical brakecontrolConfiguration of mechanical brake control.See also section Mechanical brake control (page 105).44.01 Brake control status Displays the mechanical brake control status word.This parameter is read-only.-0000h…FFFFh Mechanical brake control status word. 1 = 1No. Name/Value Description Def/FbEq16Bit Name Information0 Open command Close/open command to brake actuator (0 = close, 1 = open).Connect this bit to desired output.1 Opening torquerequest1 = Opening torque requested from drive logic.2 Hold stoppedrequest1 = Hold requested from drive logic3 Ramp to stopped 1 = Ramping down to zero speed requested from drive logic4 Enabled 1 = Brake control is enabled5 Closed 1 = Brake control logic in BRAKE CLOSED state6 Opening 1 = Brake control logic in BRAKE OPENING state7 Open 1 = Brake control logic in BRAKE OPEN state8 Closing 1 = Brake control logic in BRAKE CLOSING state9…15 Reserved
