Parameters 11503.12 Torq ref sp lim Torque reference limited by the rush control (value inpercent). Torque is limited to ensure that the speed isbetween the minimum and maximum speed limits defined byparameters 20.01 Maximum speed and 20.02 Minimumspeed.10 = 1%03.13 Torq ref to TC Torque reference in percent for the torque control. 10 = 1%03.14 Torq ref used Torque reference after frequency, voltage and torque limiters.100% corresponds to the motor nominal torque.10 = 1%03.15 Brake torq mem Torque value (in percent) stored when the mechanical brakeclose command is issued.10 = 1%03.16 Brake command Brake on/off command; 0 = close, 1 = open. For brake on/offcontrol, connect this signal to a relay output (or digital output).See section Mechanical brake control on page 72.1 = 103.17 Flux actual Actual flux reference in percent. 1 = 1%03.18 Speed ref pot Output of the motor potentiometer function. (The motorpotentiometer is configured using parameters 21.10…21.12.)100 = 1 rpm03.20 Max speed ref Maximum speed reference. 100 = 1 rpm03.21 Min speed ref Minimum speed reference. 100 = 1 rpm0404 Appl values Process and counter values.04.01 Process act1 Process feedback 1 for the process PID controller. 100 = 1 unit04.02 Process act2 Process feedback 2 for the process PID controller. 100 = 1 unit04.03 Process act Final process feedback after process feedback selection andmodification.100 = 1 unit04.04 Process PID err Process PID error, i.e. difference between PID setpoint andfeedback.10 = 1 unit04.05 Process PID out Output of the process PID controller. 10 = 1 unit04.06 Process var1 Process variable 1. See parameter group 35 Processvariable.1000 = 104.07 Process var2 Process variable 2. See parameter group 35 Processvariable.1000 = 104.08 Process var3 Process variable 3. See parameter group 35 Processvariable.1000 = 104.09 Counter ontime1 Reading of on-time counter 1. See parameter 44.01 Ontime1func. Can be reset by entering a 0.1 = 1 s04.10 Counter ontime2 Reading of on-time counter 2. See parameter group 44.05Ontime2 func. Can be reset by entering a 0.1 = 1 s04.11 Counter edge1 Reading of rising edge counter 1. See parameter group 44.09Edge count1 func. Can be reset by entering a 0.1 = 104.12 Counter edge2 Reading of rising edge counter 2. See parameter group 44.14Edge count2 func. Can be reset by entering a 0.1 = 104.13 Counter value1 Reading of value counter 1. See parameter group 44.19 Valcount1 func. Can be reset by entering a 0.1 = 104.14 Counter value2 Reading of value counter 2. See parameter group 44.24 Valcount2 func. Can be reset by entering a 0.1 = 1No. Name/Value Description FbEq
