ABB ARM600 User Manual

Also see for ARM600: Quick start guide Product guide

Contents

ABB ARM600 User Manual Manual pdf 41 page image

Section 6 Network configuration6.1 Configuring Ethernet interfacesThe Ethernet interfaces are configured using the WHMI.1. Connect the PC to ARM600's eth0 port.2. Log in to the ARM600 WHMI.3. In the left pane, under Network, click Network Configuration.4. Click the Network Interfaces icon.The Network Interfaces pane opens.5. Click Edit interface eth1 and configure the eth1 parameters.It is recommended to configure the eth1 interface (LAN) first, asthe PC is now connected to ARM600 via the eth0 interface(WAN).Change the IP address and netmask according to the requiredsetup. Either set the netmask or the prefix (number of bytes innetmask), not both.Table 10:Eth1 settingsParameter ValueDevice eth1BOOTPROTO noneIPADDR NETMASK1) PREFIX1) DEFROUTE NoIPV6_DEFROUTE No1) Set either the netmask or the prefix6. Click Save.7. Click Restart interface eth1.8. Click Edit interface eth0 and configure the eth0 parameters based on theinformation received from the Internet Service Provider or from the ICTdepartment.1MRS758861 A Section 6Network configurationARM600 27User Manual