CL settings1961SVC 440 795 M0100Password setupA password can be set up via the system menu in either RUNor STOP mode. You cannot change to the system menu if apassword is already activated.X Press DEL and ALT to call up the system menu.X Select the menu option SECURITY… to enter thepassword.X Press the OK button and move to the PASSWORD…menu.X Press OK again to enter the Password entry mode.If no password has been entered, the logic relay changesdirectly to the password display and displays four XXXXcharacters: No password present.X Press OK, four zeros will appearX Set the password using the cursor buttons:– ú í select position in the password,– ÍÚ set a value between 0 to 9.X Save the new password by pressing OK.Use OK to exit the password display and proceed with ESCand Ú to the RANGE… menu.The scope of the password has not yet been defined. Thepassword is now valid but not yet activated.h A password that has been entered in the logic relay istransferred to the memory module together with thecircuit diagram, irrespective of whether it was activated ornot.If this CL circuit diagram is loaded back from the memorymodule, the password will also be transferred to the logicrelay and is activated immediately.ENTER PASSWâXXXENTER PASSW0042
